Deck ledger at brick veneer - JLC-Online Forums

How do you guys apply a ledger over brick veneer, presuming the brick goes ... I prefer to install my deck boards slightly below grade and use an ... And the existing wall behind the brick veneer can certainly support the load.

How to Anchor a Deck to Brick Veneer - YouTube

2 May 2014 ... Want your new deck to last twice as long as others? Going crazy keeping your current deck stained? This video is part of my ebook Love Your...

How to Safely Attach a Deck to a House | This Old House

This Old House general contractor Tom Silva shows how to save a wood deck from a ... Continue to install masonry anchors, spacing them 36 to 48 inches apart.

Decks.com. Ledger Board Attachment to Brick Siding

13 Oct 2017 ... You should never attach a deck to a brick wall. In other than very old homes, exterior brick walls are only a single wythe (layer) of brick veneer.

How to deck up to walls - YouTube

31 Jul 2012 ... Versatile decking, install close to perimeter of building, install joice structure, clear of building by 15mm to allow expansion of timber.

Avoiding A Deck Collapse: Start By Attaching It Properly - Star Tribune

8 May 2012 ... To properly attach a deck ledger using 1/2" lag screws, 5/16" holes need to be ... Prairie townhouse were only attached to the fiberboard wall sheathing, ... If you look at a deck ledger and all you can see are nails holding it in...

How to Build an Attached Deck | HGTV

HGTV.com shows how to plan and construct an attached deck with these step-by-step instructions.

Step 3. Attaching the Ledger Board to the House - Perfect Pergolas

Pre-drill the pilot holes, which helps prevent the wood from splitting, using a 3mm wood ... If you attach anything to the brick or stone of an outside wall water can...

How to build & lay decking with deck boards at Homebase.co.uk

Mark on outside house walls, waste water soakaways, air bricks, manhole ... If you're attaching the deck to your house, screw the first joist to the wall but put...

Ledgers on Challenging Walls | Professional Deck Builder ...

1 Sep 2007 ... Can you attach a ledger to a concrete wall? What about to masonry veneer, stucco, EIFS, logs, SIPs, I-joists, or cantilevered floor framing?

Attaching a New Deck to a House: The Correct Method | Family ...

After the old deck is removed, you'll be able to tell if you can still use the house rim. If the wall sheathing behind the rim looks good, you're okay. But if the...

How to build a raised deck | Ideas & Advice | DIY at B&Q

A raised deck is a great way to make the most of space that can otherwise go ... Attached to a building (or wall) - ignore this section if building independently from a ... If you plan to lay a more simple deck on the ground floor, check out our .... any air bricks or interfering with the damp-proof course (DPC) by attaching the joist.

Fixing a ledger | Decking - Ultimate Handyman

How to install a ledger for decking. ... This ledger is being levelled by using a couple of bricks, which will be removed once it is fixed to the wall. frame fixings.

How to Attach a Deck to a Brick Sill | Home Guides | SF Gate

Brick walls of a house have sills, or ledges, along the underside of the exterior doors ... For a do-it-yourself enthusiast, attaching a deck at a brick sill gives you an...

Deck Building 6 - Attaching Ledger to the Wall | DoItYourself.com

There is still one crucial detail you must attend to. The situation is as follows. If the ledger were attached directly against the wall, so that the back surface of the...

How to Anchor Wooden Decking to a Wall Securely - TimberClick

How to Anchor Wooden Decking to a Wall Securely ... anchors; Sealant gun with silicone sealant; Angled metal flashing (if attaching your deck to a brick wall).

Masonry anchors for deck ledger on brick veener wall - Renovate Forums

I am building a timber deck attached to the house (brick veneer). ... I guess for your requirement you would need 150mm x 12mm dia...

Deck Flashing Code Requirements | ProTradeCraft

"Flashing is required where exterior porches, decks, or stairs attach to a wall or floor assembly of wood frame construction. Flashing ... POP Quiz: How would you flash this shape? Give up? ... Adhered Masonry Manufacturers' Association.

Installing Deck Ledgers | DIY Deck Plans

How to attach a deck ledger to a house with brick veneer. To attach a ledger against a wall through brick veneer: Mark anchor locations on your ledger and drill...

How to lay a deck | Wickes.co.uk

If you are building a fixed deck that joins onto a house then you will need to attach a wall plate. ... This line will be the guideline for attaching the wall plate to the wall so extend this ... Drill guide holes into the wall using a 7mm masonry drill bit.

Related Posts:

Random Posts: